Asbestguard
Full matt
AsbestGuard is a water-borne functional coating, suitable for encapsulation of asbestos and sealing of asbestos that can not be removed as a result of the construction conditions. AsbestGuard's unique properties, fire protection (EN13501-1, Class A2-s1d0), condense prevention, insulation and noise damping, assures the technical properties of the asbestos.
- Applications
-
805
-
12 h
-
1 h
-
Finish
-
Full matt
AsbestGuard is a water-borne functional coating, suitable for encapsulation of asbestos and sealing of asbestos that can not be removed as a result of the construction conditions. AsbestGuard's unique properties, fire protection (EN13501-1, Class A2-s1d0), condense prevention, insulation and noise damping, assures the technical properties of the asbestos.
Product Features
Suitable for asbestos encapsulation when the asbestos cannot be removed.
Recommended Uses
AsbestGuard is suitable for interior treatment of asbestos-cement or asbestos-sprayed concrete surfaces, acoustic panels, ventilation insulation and pipes. Read the application instructions carefully before starting the painting work. When treating a substrate containing asbestos, the law no. 684/2015 and Council of State decision no. 798/2015 on asbestos work must be followed.
Depending on the surfaces. (see Application).
Thinner
Waterborne
The surface to be painted must be dry, the temperature at least +5°C and the relative humidity of the air below 80%.
Surface preparation
Always investigate the condition of the asbestos-treated substrate or asbestos-cement. Avoid encapsulation of asbestos substrates in bad conditions and where the substrate is exposed to mechanical wear. The law no. 684/2015 and Council of State decision no. 798/2015 on asbestos work must be followed.
Painting
First coat:
Sanitation - sealing of asbestos: After removal of asbestos, vacuum clean all asbestos covered surfaces well. Seal the possible asbestos fibre dust by spraying the surfaces with a thin layer of ProSeal (10m²/l) to seal remaining dust. Asbestos-sprayed surfaces - sealing of asbestos: Spray the surface with a thin layer of ProSeal (5m²/l) to seal remaining dust. Encapsulate the surface by applying AsbestGuard 2 times by airless spray 0,5-1m²/l ( spreading amount 1-2kg/m²) for even and seamless surfaces. For coarse surface, consumption should be increased. Asbestos-cement boards -encapsulating: Spray the surface with a thin layer of ProSeal (10m²/l) to seal remaining dust. Encapsulate the surface by applying AsbestGuard 1 time by airless spray 1m²/l (or 1 kg/m²). Conditioned air ducts - Encaps insulation surfaces: Spray the surface with a thin layer of ProSeal (10m²/l) to seal remaining dust. Encapsulate the surface by applying AsbestGuard 2 times by airless spray 0,5-1m²/l ( spreading amount 1-2kg/m²) for even and seamless surfaces. Mix the product well before use. The product is ready to use and should not be diluted.
Maintenance Instructions
Avoid high-pressure cleaning.
Applications
AsbestGuard is applied by airless spray, brush, or roller. ProSeal primer can be used for binding asbestos fibers remaining after asbestos removal.

You’re visiting Tikkurila website from United Kingdom. Would you like to visit the local UK site?