Finnseco Ylitasoituslaasti

Polymer-modified cement mortar, with a maximum grain size of 0.6 mm.

Avainlippu CE

Finnseco Ylitasoituslaasti

Polymer-modified cement mortar, with a maximum grain size of 0.6 mm.

Description

Polymer-modified cement mortar, with a maximum grain size of 0.6 mm.


Product Features

Leveling render for clean surfaces, e.g., sand-blasted concrete, slowing down the carbonation of concrete and forming a smooth surface for the actual coating.


Recommended Uses

Residential, commercial, industrial and storage buildings and others.


Coverage

Approx. 4 kg/m² (approx. 2 mm coat).


Application Conditions

The temperature of air, mortar and substrate must be at least +5 °C. Avoid working when it is hot or in direct sunlight.


Surface preparation

Remove the existing coating or paint by sand-blasting. Remove any loose or damaged concrete, expose the corroded reinforcement bars by chipping and clean them of rust to at least grade St2. Carefully remove all grinding and chipping waste. Treat the cleaned steel with Finnseco-KOR anti-corrosion paint and make any required repairs with Finnseco repair mortars according to the work instructions. MIXING THE MORTAR Add Finnseco Ylitasoituslaasti into clean water (3.5–4.5 l water to 25 kg dry product) and mix mechanically to an even consistency. Let the mix stand for approx. 10 minutes before mixing again and starting work.


Painting

First coat:

Wet the surface thoroughly on the previous day and again 1 to 2 hours before starting to apply the coating. You can start applying the mortar when the surface is no longer glossy. Spraying Spray the mortar on mechanically and level it with a steel or cellular rubber float. You can finish the surface lightly with a sponge float in 10–40 minutes from application, according to the conditions. On exposed-aggregate surfaces, brush the mortar into a compact coat 2–3 mm thick on the substrate immediately after spraying. Finish the following day by spraying a thin coat of mortar onto the surface. Application with a trowel Apply a 2–3 mm thick coat of mortar manually with a steel or cellular rubber float. You can finish the surface lightly with a sponge float in 10–40 minutes from application, according to the conditions. NOTE! Only mix as much mortar as you can use in an hour. When treating a substrate containing asbestos, follow the Government Decision on Asbestos Work (1380/1994) and the related Decrees 318/2006 and 863/2010.


English
has been added to saved.
has been removed from saved.
en