Fontefloor EP-FD Primer

A two-component fast drying pigmented waterborne epoxy primer

• Seals the concrete surface and ensures good adhesion for Tikkurila Fontefloor paints and Temafloor coatings. • Fast drying. • White pigmented. • Good watervapour permeability. • The M1 classification for low-emitting building materials has been granted by the Finnish Building Information Foundation RTS.

• Used for dust binding and priming of concrete floors.

Coverage on concrete floors is on the average: Priming 5-7 m2/l Practical coverage depends on the porosity and evenness of the substrate and on the application method.

Waterborne

rubber trowel, roller

The relative humidity of the concrete should not exceed 97%. Residual moisture content should be below 4 weight-%. The temperature of the ambient air, surface or coating should not fall below +15ºC during application or drying. Relative humidity of air should not exceed 80 %.

Always remove all grease, oil, and other impurities with Maalipesu detergent before grinding. Remove laitance or old paint layers by power grinding, milling, or vacuum grit blasting. Choose the method best suited for the premises. Clean out pot holes removing all loose or brittle material. Open cracks with e.g. an abrasive tool. After mechanical pre-treatment remove all loose material and dust carefully with a vacuum cleaner. The substrate must have a tensile strength above 1.5 MPa. For application on cementitious leveling screed: check compatibility with the leveling screed manufacturer

Water. Equipment should be cleaned immediately after use before the paint has dired.

VOC 2004/42/EC (cat A/j) 140 g/l (2010) Fontefloor EP-FD Primer: max. VOC < 140 g/l