Fontefloor EP Primer

A two-component water-borne epoxy primer.

M1 CE

Fontefloor EP Primer

A two-component water-borne epoxy primer.

Finish

  • Semi-gloss

Description

A two-component water-borne epoxy primer.


Product Features

• Seals the concrete surface and confirms adhesion prior to Temafloor coatings and screeds and Fontefloor paints. • Suitable for priming of damp concrete (relative humidity of the concrete over 97%) surfaces prior to Fontefloor EP 100 epoxy paint. • Good water vapour permeability. • Can be used for patching cracks and holes in concrete. • The M1 classification for low-emitting building materials has been granted by the Finnish Building Information Foundation RTS.


Recommended Uses

• Used for dust binding and priming of untreated concrete floors.


Thinner

Waterborne


Application Conditions

The relative humidity of the concrete should not exceed 97%. Residual moisture content should be below 4 weight-%. The temperature of the ambient air, surface or coating should not fall below +15ºC during application or drying. Relative humidity of air should not exceed 80%.


Surface preparation

Always remove all grease, oil, and other impurities with Maalipesu detergent before grinding. Remove laitance or old peeling paint layers by power grinding, milling, or vacuum grit blasting. Choose the method best suited for the premises. Clean out pot holes removing all loose or brittle material. Open cracks with e.g. an abrasive tool. After mechanical pre-treatment remove all loose material and dust carefully with a vacuum cleaner. The substrate must have a tensile strength above 1.5 MPa. For application on cementitious leveling screed: check compatibility with the leveling screed manufacturer.


Painting Cleaning of tools

Water. Equipment should be cleaned immediately after use before the paint has dried.


VOC

VOC 2004/42/EC (cat A/j) 140 g/l (2010) Fontefloor EP Primer: max. VOC < 140 g/l


Universal primer

Fontefloor EP Primer seals the concrete surface and provides adhesion to all Temafloor coatings and screeds, and Fontefloor paints. It can be also used for patching cracks and holes in concrete.

Product usp1prof_img
Primed concrete floor

Fast-drying varnish

Fontefloor EP Primer dries in 6 hours for overcoating. This varnish is also used for priming of damp concrete with relative humidity over 97% prior to Fontefloor EP 100 epoxy paint.

Product usp2prof_img
Quick priming
English
has been added to saved.
has been removed from saved.
en