Novopox P

A two component solvent-free epoxy lacquer.

CE

Novopox P

A two component solvent-free epoxy lacquer.

  • 8010
  • 4 m²/l
  • 10 m²/l
  • 12 h
  • 3 h
Description

A two component solvent-free epoxy lacquer.


Product Features

Used for impregnating and priming prior to treating with Novopox LP epoxy coating. Thinned Novopox P epoxy primer is absorbed well into the pores of the concrete, sealing the base and ensuring the adhesion of the coating to the substrate. Can also be used for patching concrete floors when filled with sand. Only for professional use.


Recommended Uses

For old and new concrete floors and balcony concrete floors.


Coverage

Coverage depends on the porosity and evenness of the substrate and on the application method. Coverage on cement floors is on average: I priming 4-8 m²/l II priming 6-10 m²/l


Application Conditions

The concrete surface must be dry and at least 4 weeks old. The relative humidity of the concrete should not exceed 97 %. The temperature of the ambient air, surface and coating should not fall below + 10 °C during either application or drying. The relative humidity of air should not exceed 80 %.


Surface preparation

New cement floors: Remove the laitance layer from the concrete surface by surface sanding or hydrochloric acid pickling. After cleaning, carefully remove the dust with a vacuum cleaner. Hydrochloric acid pickling is carried out with diluted hydrochloric acid (1 part concentrated hydrochloric acid, 4 parts water). Rinse the floor with plenty of water. Dry the floor. Old cement floor: Remove all dust and loose material from the floor. Remove all grease, oil, chemicals and other impurities by emulsion cleaning, grinding, milling, flame cleaning or abrasive blasting. Choose the method best suited for the premises in question. Remove old peeling paint films. Clean out holes and cracks on the floor until you reach healthy, clean concrete. Open cracks with, for example, an edge grinder. Remove all loose material and dust.


Painting

First coat:

Coating may be carried out no less than 6 hrs (+23 °C) and no more than 24 hrs after priming and patching. If the primed surface is not coated within 24 hrs, it should be sanded. Porcupine the surface right after the treatment to even out the coating film and remove air bubbles.


Cleaning of tools

Epoxy thinner 1074


Maintenance Instructions

The painted surface reaches ultimate durability and hardness in approximately 2 weeks after surface treatment under normal conditions. Avoid cleaning during this time. Clean the surface with a brush, mop or dust cloth. Clean soiled surfaces with a cleaning tool and neutral (pH 6-8) detergent.


Successful outcome

Novopox P is suitable as a primer for new and old concrete floors. It is ideal for priming concrete floors in balconies. Filled with sand, Novopox P can also be used to patch concrete floors.

Impermeable lacquer finish

Novopox’s solvent-free composition creates a full-gloss and clear lacquer finish on concrete floors.

Easily absorbed

When thinned, Novopox P is absorbed well into the pores of the concrete, sealing the base and ensuring the adhesion of the coating to the substrate. It can be applied with a paintbrush, mohair roller, or steel or rubber spatula.

English
has been added to saved.
has been removed from saved.
en