Temafloor 400

A two-component solvent-free epoxy varnish.

CE

Temafloor 400

A two-component solvent-free epoxy varnish.

Finish

  • High gloss

Description

A two-component solvent-free epoxy varnish.


Product Features

• Used as a binder for Temafloor 4000 troweling screed and epoxy concrete. • Used also as a topcoat on top of Temafloor coatings and screeds. • Filled with sand also suitable for patching of concrete floors.


Recommended Uses

• Suitable for dust binding and priming of new and old concrete floors under Temafloor coatings.


Coverage

Coverage on concrete floors is on the average: Primer 5–8 m²/l and topcoat 6–10 m²/l. Practical coverage depends on the porosity and evenness of the substrate and on the application method.


Thinner

Solventfree


Application Conditions

The relative humidity of the concrete should not exceed 97%. Residual moisture content should be below 4 weight-%. The temperature of the ambient air, surface or coating should not fall below +15ºC during application or drying. Relative humidity of air should not exceed 80%.


Surface preparation

Always remove all grease, oil, and other impurities with Maalipesu detergent before grinding. Remove laitance or old peeling paint layers by power grinding, milling, or vacuum grit blasting. Choose the method best suited for the premises. Clean out pot holes removing all loose or brittle material. Open cracks with e.g. an abrasive tool. After mechanical pre-treatment remove all loose material and dust carefully with a vacuum cleaner. The substrate must have a tensile strength above 1.5 MPa. For application on cementitious leveling screed: check compatibility with the leveling screed manufacturer.


Painting Cleaning of tools

Thinner 1029.


VOC

VOC 2004/42/EC (cat A/j) 500 g/l (2010) Temafloor 400: max. VOC < 500 g/l


Multi-purpose epoxy lacquer

Temafloor 400 is excellent product for dust binding and priming of new and old concrete floors, especially where solventless and odourless products are needed. The lacquer can be used for patching when filled with sand.

Product usp1prof_img
Good for dust binding

Suitable for priming, screeding and topcoating

This lacquer is a main component of Temafloor 4000 grinding screed. Temafloor 400 also can be apply on the top of Temafloor coatings and screeds. It can be used with mosaic flakes as a top lacquer to increase anti-slip properties.

Product usp2prof_img
Can be used to fill cracks
English
has been added to saved.
has been removed from saved.
en