Fontefloor EP 100

A two-component water-borne epoxy paint for interior applications.

• For painting of new, old and earlier painted concrete floors. • Also suitable for painting concrete, plaster and gypsum walls. • Fontefloor EP 100 belongs to emission class M1 for building materials. • Fulfils the decontamination test requirements (FRP < 15 000) according to the standard ISO 8690:1988 (STUK-YTO-TR-210).

• Recommended for coating of floors exposed to moderate chemical and mechanical stress in industrial facilities, warehouses, repair shops etc.

Coverage on concrete floors is on the average: Priming 5–7 m²/l Finishing 7–10 m²/l Practical coverage depends on the porosity and evenness of the substrate and on the application method.

Waterborne

The relative humidity of the concrete should not exceed 97%. The residual moisture of the substrate must not exceed 4%. The temperature of the ambient air, surface or coating should not fall below +15ºC during application or drying. Relative humidity of air should not exceed 80%. Note! There is a natural tendency of this coating to chalk, discolor or yellow unevenly. It is recommended to use polyurethane topcoat when there are high aesthetical requirements on color appearance.

Always remove all grease, oil, and other impurities with Maalipesu detergent before grinding. Remove laitance or old peeling paint layers by power grinding, milling, or vacuum grit blasting. Choose the method best suited for the premises. Clean out pot holes removing all loose or brittle material. Open cracks with e.g. an abrasive tool. After mechanical pre-treatment remove all loose material and dust carefully with a vacuum cleaner. The substrate must have a tensile strength above 1.5 MPa. For application on cementitious leveling screed: check compatibility with the leveling screed manufacturer.

Water. Equipment should be cleaned immediately after use before the paint has dried.

VOC 2004/42/EC (cat A/j) 140 g/l (2010) Fontefloor EP 100: max. VOC < 140 g/l