Fontefloor EP Clear
Full gloss
A two-component water-borne epoxy lacquer.



- Multi-purpose lacquer
- Forms easy-to-clean surface
Finish
-
Full gloss
A two-component water-borne epoxy lacquer.
Product Features
• For lacquering of new, old and earlier painted concrete surfaces. • To be used on top of Fontefloor EP 100 and other Temafloor coatings. • Also suitable for dust binding and lacquering of concrete walls. • The M1 classification for low-emitting building materials has been granted by the Finnish Building Information Foundation RTS.
Recommended Uses
• Recommended for lacquering of floors exposed to moderate chemical and mechanical stress in industrial facilities, warehouses, repair shops etc.
Coverage on concrete floors is on the average: Priming 5–8 m2/l Finishing 6–10 m2/l Practical coverage depends on the porosity and evenness of the substrate and on the application method
Thinner
Waterborne
The relative humidity of the concrete should not exceed 97%. Residual moisture content should be below 4 weight-%. The temperature of the ambient air, surface or coating should not fall below +15ºC during application or drying. Relative humidity of air should not exceed 80%.
Surface preparation
Always remove all grease, oil, and other impurities with Maalipesu detergent before grinding. Remove laitance or old peeling paint layers by power grinding, milling, or vacuum grit blasting. Choose the method best suited for the premises. Clean out pot holes removing all loose or brittle material. Open cracks with e.g. an abrasive tool. After mechanical pre-treatment remove all loose material and dust carefully with a vacuum cleaner. The substrate must have a tensile strength above 1.5 MPa. For application on cementitious leveling screed: check compatibility with the leveling screed manufacturer.
Painting Cleaning of tools
Water. Equipment should be cleaned immediately after use before the lacquer has dried.
VOC
VOC 2004/42/EC (cat A/j) 140 g/l (2010) Fontefloor EP Clear: max. VOC < 140 g/l