Temafloor 400

A two-component solvent-free epoxy varnish.

CE

Temafloor 400

A two-component solvent-free epoxy varnish.

Finish

  • High gloss

Description

A two-component solvent-free epoxy varnish.


Product Features

• Used as a binder for Temafloor 4000 troweling screed and epoxy concrete. • Used also as a topcoat on top of Temafloor coatings and screeds. • Filled with sand also suitable for patching of concrete floors.


Recommended Uses

• Suitable for dust binding and priming of new and old concrete floors under Temafloor coatings.


Coverage

Coverage on concrete floors is on the average: Primer 5–8 m²/l and topcoat 6–10 m²/l. Practical coverage depends on the porosity and evenness of the substrate and on the application method.


Thinner

Solventfree


Application Conditions

The relative humidity of the concrete should not exceed 97%. The temperature of the ambient air, surface or coating should not fall below +15ºC during application or drying. Relative humidity of air should not exceed 80%. Note! There is a natural tendency of this coating to chalk, discolor or yellow unevenly. It is recommended to use polyurethane topcoat when there are high aesthetical requirements on color appearance.


Surface preparation

New concrete: Remove laitance by power grinding, vacuum grit blasting or hydrochloric acid etching. Choose the method best suited for the premises. After grinding remove dust carefully with a vacuum cleaner. Hydrochloric acid etching is carried out with diluted hydrochloric acid (1 part concentrated hydrochloric acid, 4 parts water). Rinse with plenty of water. Dry the floor. Old concrete: Remove all grease, oil, chemicals and other impurities by Maalipesu detergent. Remove old peeling paint layer by grinding or vacuum grit blasting. Choose the method best suited for the premises. Clean out pot-holes removing all loose friable material. Open cracks with e.g. an abrasive tool. Remove loose material and dust. If cementitious screed is used, check compatibility with the levelling screed manufacturer.


Painting Cleaning of tools

Thinner 1029.


VOC

Limit value (Cat A/j): 500 g/l (2010).
Product VOC < 500 g/l.
VOC 2004/42/EC (cat A/{Phrase5_Key1}) {Phrase5_Key2} g/l (2010).

Multi-purpose epoxy lacquer

Temafloor 400 is excellent product for dust binding and priming of new and old concrete floors, especially where solventless and odourless products are needed. The lacquer can be used for patching when filled with sand.

Product usp1prof_img
Good for dust binding

Suitable for priming, screeding and topcoating

This lacquer is a main component of Temafloor 4000 grinding screed. Temafloor 400 also can be apply on the top of Temafloor coatings and screeds. It can be used with mosaic flakes as a top lacquer to increase anti-slip properties.

Product usp2prof_img
Can be used to fill cracks
has been added to saved.
has been removed from saved.