Design floors - Stained concrete work instructions

Pre-treatment:

1. The concrete floor should be prepared according to the instructions of the Data Sheet.

Stained finish:

1. Ensi Urethane Oil and the tinted Betolux Floor Pint are mixed separately in their cans. Then you can produce a mix in a desired mixing ratio, e.g. 1:6. By changing the Betolux shades and the mixing ratio, you can achieve  different results.
2. The ready-made mixture is thinned 10–20% using White Spirit 1050.
3. The mixture is spread onto the floor using a thin rubber spatula. The mixture should be absorbed completely into the concrete after drying.
    To avoid  working day joints, the mixture is levelled using the "criss-cross" method. If necessary, treat the floor one more time using only Ensi Urethane Oil after 12–24 h.

Note!

The system is suitable for dark colors only, tinted of C base, because light colors tend to turn yellow.