Isoxyde
Matt
Hydrophobic water-borne thick layer paint based on a combination of acrylic and styrene polymers. Contains anti-corrosion agents.


- Effective protection against corrosion
- High covering weather resistance
- Wide range of ready made shades
-
858
-
3.5 m²/l
-
5 m²/l
-
6 h
-
3 h
-
-
-
Finish
-
Matt
Hydrophobic water-borne thick layer paint based on a combination of acrylic and styrene polymers. Contains anti-corrosion agents.
Product Features
Suitable for iron, aluminum, zinc, galvanized surfaces, plastisol plates, polyester and alkyd surfaces. Can be used without a primer. Not suitable for maintenace painting of PVDF treated roofs. The product is also suitable for maintenance painting of metal surfaces painted with solventborne or waterborne metal roof paints. Can be used without a primer.
Recommended Uses
Roofs and metal structures.
5 m²/l (200 μm wet film/ 80 μm dry film). If the substrate is in a good condition and only needs a touch up, 1 layer is sufficient. Otherwise apply two layers with total coverage of 2,5 m²/l, (400 μm wet film/ 160 μm dry film). The practical spreading rate depends on application method, form and surface of the material.
Thinner
Waterborne
Application Method
spraying, brush, roller
The temperature must be between +8° C and +30° C and relative humidity below 85 % RH.
Surface preparation
New surfaces: If Isoxyde is used on galvanized steel, the surface must be cleaned from white rust, dirt, salt, grease and oil with Panssaripesu cleaning agent by using brush. Rinse carefully with water and let dry. Remove from the surface possible rest of white rust/rust by sanding or by metalbrush (cleaning degree St2). Aluminium surfaces must be roughned before painting. Treat corroded surfaces with RustConverter before application or prime with Rostex Super or Rostex Super Akva. The surface must be clean, dry, and stabile. New zinc-coated sheet metal roofs should be painted after one winter at the earliest. New surfaces can also be painted immediately, but then the surfaces must be roughned mechanically or chemically before painting. The best adhesion will be achieved on a mechanically or chemically roughened zinc-coated surface that has been dimmed by the weather. Previously painted surfaces: Clean previously painted surfaces thoroughly with Tikkurila Panssaripesu and hot water so that all dirt, grease and loose paint is removed. If Isoxyde is used on galvanized steel, the surface must be cleaned from white rust, dirt, salt, grease and oil with Panssaripesu cleaning agent by using brush. Rinse carefully with water and let dry. Remove from the surface possible rest of white rust/rust by sanding or by metalbrush (cleaning degree St2). Aluminium surfaces must be roughned before painting. Treat corroded surfaces with RustConverter before application. The surface must be clean, dry, and stabile.
Painting
First coat:
Stir Isoxyde well before use. Apply with a brush, roller or airless spray (nozzles 19 – 21, 180 - 220 bar). To ensure the optimum film thickness apply the paint in two layers. Use unthinned. The viscosity may be adjusted downwards when thinning with max. 5 % water. Always make a test coat to ensure the compatibility of product and surface.
Maintenance Instructions
After one month from painting, a dirty surface can be cleaned with Huoltopesu (mix 1 part of Huoltopesu with 10 parts of water). Clean stains and very dirty surfaces with a stronger Huoltopesu solution (1:1). After washing, rinse with water and let dry.
VOC
(cat A/d) 130 g/l (2010) Isoxyde contains VOC max. 130 g/l